Glitter Cutter Settings
|
Cricut: Blade: Standard Setting: Iron-on+
|
Silhouette Cameo: Blade: Standard, 4 Material: Heat Transfer, Smooth Speed: 8 Force: 11
|
Brother ScanNCut: Blade: Standard, 3 Cut Speed: 1
Cut Pressure: 5
|
Roland GX/GS-24: Blade: 45° Gram Force:180-190 Offset: .250 Speed: 30 cm/s
|
Graphtec: Blade: 45° Force: 17 Tool:CB09+0 Speed: 30 cm/s
|
MH, SC2, LP3, and Titan1: Blade: 45°/60° Gram Force: 120-130 Speed: 300 mm/s
*Blade Advancing Varies |
Titan 2 & 3: Blade: 45°/60° Gram Force: 100-110 Speed: 300 mm/s
*Blade Advancing Varies
|
Application Settings (Home Iron) |
• Set iron dial between Cotton and Linen • Cover with Heat Transfer Cover Sheet or Multipurpose Paper • Place on flat, hard surface (ironing board not recommended) • Press iron with medium/firm pressure (do not slide iron) • Press each section of design for 15-20 seconds • If areas of design lift after application, replace cover sheet and re-press for 10 seconds • Peel carrier warm |
Application Settings (Heat Press) |
• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Preheat garment for 2-3 seconds • Apply design at 320°F/160°C • Use medium pressure for 15-20 seconds • Peel carrier warm |