Easypattern HTV requires TTD High tac mask (sold separately)**
EasyPatterns® Cutter Settings |
Cricut:
Blade: Standard Setting: Iron-on
|
Silhouette Cameo:
Blade: Standard, 3 Material: Heat Transfer, Smooth Speed: 8 Force: 6
|
Brother ScanNCut:
Blade: Standard, 2 Cut Speed: 1
Cut Pressure: 1 |
Roland GX/GS-24:
Blade: 45° Gram Force:80-90 Offset: .250 Speed: 25-50 cm/s
|
Graphtec:
Blade: 45° Force: 8-9 Tool:CB09U+0 Speed: 25 cm/s
|
MH, SC2, LP3, and Titan1:
Blade: 45°/60° Gram Force: 80-85 Speed: 300 mm/s
*Blade Advancing Varies |
Titan 2 & 3:
Blade: 45°/60° Gram Force: 80-85 Speed: 300 mm/s
*Blade Advancing Varies
|
Click Here for all Cutter Settings
Please Note: Due to increased heat and humidity during the summer months, we recommend allowing TTD Masks to return to indoor room temperature (below 70°F/21°C) before use for best performance. If additional cooling is needed, TTD Masks can be placed inside a fridge or freezer for 5- 10 minutes. |
Application Settings (Home Iron) |
• Cut design in positive (Don't Mirror) • Weed Excess Material • Mask with TTD High Tack Mask (Sold separately) • Set iron dial between Cotton and Linen • Cover with Heat Transfer Cover Sheet or Multipurpose Paper • Place on flat, hard surface (ironing board not recommended) • Press iron with medium/firm pressure (do not slide iron) • Press each section of design for 15 seconds • If areas of design lift after application, replace cover sheet and re-press for 10 seconds • Peel carrier hot or cold |
Application Settings (Heat Press) |
• Cut design in positive (Don't Mirror)
• Weed Excess Material • Mask with TTD High Tack Mask (Sold separately) • Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Preheat garment for 2-3 seconds • Apply design at 305°F/150°C • Use medium pressure for 10-15 seconds • Peel carrier hot or cold |
Click Here for a printable version of all HTV Application instructions